First, before the power on, need to drain before the remaining sewage.

Secondly, moisten the thread of the loom, reed and heald wire with water again to soften the residual slurry, so as to avoid the residual hard pulp block during direct driving to pull the thread and break it.

Third, switch on the power, plug in the line control panel, open the water supply valve of the water tank, test the power and water supply, and observe whether the water and electricity are normal.

Fourthly, if it is necessary to change the variety and specification of the blank silk, the weft density can be changed by replacing the weft wire and the appropriate let-off and coiling gear.

Fifthly, if the reed falls seriously in the wire, resulting in the fluff of warp wire, etc., the warp wire can be shaken by hand through the weaving mouth a few centimeters to more than ten centimeters, according to the specific circumstances, then try to start the car.