The operation process of the composite multi-functional intelligent spinning machine will vary depending on the specific equipment model and function. In general, the following is a basic operating process:

1. Preparation: Check whether all parts of the equipment are normal, including power supply, feeding system, spinning components, etc. Prepare the required materials and tools according to the experimental requirements.

2. Set parameters: According to the specific requirements of the experiment, set the parameters of the spinning machine, such as temperature, pressure, speed, etc.

3. Feed: feed the raw material into the spinning machine through the feeding system.

4. Spinning: Start the spinning machine, so that the melt is extruded from the spinning component to form a fiber.

5. Stretching: As needed, the fiber is stretched to adjust the performance of the fiber.

6. Winding: The stretched fiber is wound into a roll for subsequent processing and analysis.

7. Cleaning: After the end of the experiment, clean the equipment, including cleaning the spinning components, replacing the filter screen, etc.

During operation, note the following points:

1. Strictly follow the operation instructions of the device to avoid misoperation.

2. Pay attention to safety, avoid high temperature, high pressure and other dangerous situations.

3. Maintain and maintain the equipment regularly to ensure the normal operation of the equipment.

4. During the experiment, we should pay close attention to the formation of fibers and adjust the parameters in time to obtain the ideal experimental results.